A traverse rod makes it simple to “traverse” or move your drapery panels across the window or door. Instead of pulling on the fabric with your hands, you can pull on the cord to smoothly slide the drapery out of the way. Pleated draperies are most often the type you will see installed on traverse rods.Click to see full answer. Regarding this, how do drapery rods work?Traverse rods have clips or eyes that move along a track embedded in a slot in the rod. The eyes have a small opening for the curtain pins and they’ll run evenly across the rod, with the number of eyes dependent on how long the rod is. A cord runs through the rod, too, and is attached to a master slide or pulley.Secondly, how do you fix curtain rods? Remove the curtain rod from the rod mounts. Locate the damaged drywall where the curtain rods were mounted. Tap a small plastic anchor into each hole in the drywall with a hammer. Position the curtain mount over the two anchors and insert a matching screw through the top and bottom holes of the mount into the anchors. Also Know, how do you hang curtains on a traverse rod? How to Hang Curtains on a Traverse Rod Insert a drapery pin on the back of the drapes in the middle of each pleat. Insert a drapery pin on the back at the end of each drape. Begin at the master overlap carrier, which is the mechanism that overlaps one side of the drapes over the other side when the drapes are closed. What type of curtain rod do I need?Selecting the Right Size. Choose a curtain rod with a diameter of at least 1 inch (2.5 cm). Thin curtain rods tend to look cheap and can bow under the weight of your drapes if they are heavy. When choosing a curtain rod, look for a rod that is at least 1 inch (2.5 cm) thick for good aesthetics and curtain support.
ncG1vNJzZmivp6x7pLHLnpmroaSesrSu1LOxZ5ufonuotI6wn5qsXZ7Abq2MramapqOrsrO%2FxGaarqqklravedGom2g%3D